Difference between revisions of "Exit Protocol"
From Bloominglabs
| Line 12: | Line 12: | ||
* That the laser/fan is powered off; and <b>the vent is closed</b>. (this is very important in winter, the laser tube has water in it) | * That the laser/fan is powered off; and <b>the vent is closed</b>. (this is very important in winter, the laser tube has water in it) | ||
* Turn the lights off. | * Turn the lights off. | ||
| − | * | + | * Make sure the door locks behind you. |
[[Image:Qrcode_blabs_exit_protocol.jpg|none|thumb|100px|Link to latest version of this document]] | [[Image:Qrcode_blabs_exit_protocol.jpg|none|thumb|100px|Link to latest version of this document]] | ||
Revision as of 14:33, 11 March 2016
If you are the last person to leave the space, please take a minute and check the following:
- That there are no fires. If there are, would you kindly put them out?
- That you have returned tools to their proper place and cleaned up your work area.
- That the door by the welding station, the garage door, and the front/main door are all locked.
- Winter:
- The door between the workshop and the meeting room is open.
- The thermostat is set to 60°f, if winter (thermostat is in the mud room in the workshop).
- Summer:
- The door between the workshop and the meeting room is closed.
- The AC is set to ~70°f and energy saver mode.
- That the laser/fan is powered off; and the vent is closed. (this is very important in winter, the laser tube has water in it)
- Turn the lights off.
- Make sure the door locks behind you.
