Edit: This info has become a little out of date after our move to a new building on 8-2014. The A/V cabinet is currently located in the office/clean area just left of the large whiteboard. Currently any TV in the space supports these channels: 8 for the laser cutter, 10 for the workshop/car lift view, and channel 99 is a multiplexor which combines multiple feeds.
We have a closed circuit TV network in our space. We have several video sources which can deliver video to the network and hope to support multiple methods of output. The most practical use is to keep an eye on the laser cutter while it's running (fire kills lasers). A number of input sources are available which can deliver the content to all the other rooms in the space. Also the system can be used to play music throughout the space, as well as watch movies and other fun things.
How to use the A/V rack
- If it's not already on, turn on the power strip in the bottom of the rack, it is dark grey and may be somewhat buried - the cord and strip are labled, the cord runs into the front of the rack.
- Select an A/V source from the 8 channel switcher (VGA from front room, MAME cabinet, DVD player, PCH/Pop Corn Hour, VCR, etc.)
- Power on the A/V source if required (DVD player, VCR, etc)
- Turn on the TV in the room you wish to view the A/V feed
- When you are the last person out of the space or done with the A/V rack please turn it off (along with any TV’s or projectors)
- Pop Corn Hour network streaming device
- VGA to composite input (MAME cabinet)
- VGA to composite input from the office table
- 5-disk DVD changer
- Composite feed from laser room (camcorder - view of laser cutter bed)
Composite feed from front room (unconnected) Additionally we can switch to our cable TV feed (which comes with our cable internet access).
Kramer VS-801N with 8 inputs to 1 output (2 parallel outputs), serially and manually controlled.
We have a frequency agile RF modulator currently set for channel 8 (Laser cutter). Channel 10 is the workshop, and channel 99 is the MAME cabinet
A 4-way low-noise video splitter is being used to feed the TV's throughout the space and a monitor on top of the A/V rack.
- All TV's on the coax network
- Projector in front room (2nd composite output of switcher to VGA converter in A/V rack)
- RF Modulators waiting to be installed - ChannelPlus 5525 dual channel agile modulator, a Blonder Tongue agile modulator, and modulator factory set for channel 10.
- 16 input Bosch Video multiplexor - video only, can combine multiple video feeds into a single display (4x4, 8x8, etc)
- Video to IP so members outside the space can see what is on the CCTV network